diff --git a/chapter10/kernel.xml b/chapter10/kernel.xml
index a168d6518..33b0cba2a 100644
--- a/chapter10/kernel.xml
+++ b/chapter10/kernel.xml
@@ -45,6 +45,37 @@
in the kernel source tree for alternative methods to the way this book
configures the kernel.
+
+
+ Building the linux kernel for the first time is one of the most
+ challenging tasks in LFS. Getting it right depends on the specific
+ hardware for the target system and your specific needs. There are
+ almost 12,000 configuration items that are available for the kernel
+ although only about a third of them are needed for most computers. The
+ LFS editors recommend that users not familiar with this process follow
+ the procedures below fairly closely. The objective is to get an
+ initial system to a point where you can log in at the command line when
+ you reboot later in . At his point
+ optimization and customization is not a goal.
+
+
+
+
+ For general information on kernel configuration see . Additional information
+ about configuring and building the kernel can be found at . These refereces are a bit
+ dated, but still give a reasonable overview of the process.
+
+
+
+ If all else fails, you can ask for help on the lfs-suport
+ mailing list. Note that suscribing is required in order for the list
+ to avoid spam.
+
+
+
Prepare for compilation by running the following command:
make mrproper
@@ -88,10 +119,6 @@
- For general information on kernel configuration see . Additional
- information about configuring and building the kernel can be found at
- .
A good starting place for setting up the kernel configuration is to
@@ -186,7 +213,7 @@ Device Drivers --->
(X) 64GB [CONFIG_HIGHMEM64G]
If the partition for the LFS system is in a NVME SSD (i. e. the
- device node for the parition is /dev/nvme*
+ device node for the partition is /dev/nvme*
instead of /dev/sd*), enable NVME support or
the LFS system won't boot: