Add 3DPrinter-Remote

3dprinter-remote/rootfs/etc/cont-init.d/ser2net.sh

@@ -0,0 +1,14 @@
+#!/usr/bin/with-contenv bashio
+# ==============================================================================
+# Add-on: 3dprinter-remote
+# Setup ser2net.conf
+# ==============================================================================
+
+# Generate ser2net configuration
+bashio::var.json \
+    printer_path "$(bashio::config 'printer_path')" \
+    printer_baudrate "$(bashio::config 'printer_baudrate')" \
+    ser2net_args "$(bashio::config 'ser2net_args')" \
+    | tempio \
+        -template /usr/share/tempio/ser2net/ser2net.conf.gtpl \
+        -out /etc/ser2net.conf

3dprinter-remote/rootfs/etc/services.d/ser2net/finish

@@ -0,0 +1,9 @@
+#!/usr/bin/execlineb -S0
+# ==============================================================================
+# Add-on: mjpg-streamer
+# Take down the S6 supervision tree when mjpg-streamer fails
+# ==============================================================================
+if -n { s6-test $# -ne 0 }
+if -n { s6-test ${1} -eq 256 }
+
+s6-svscanctl -t /var/run/s6/services

3dprinter-remote/rootfs/etc/services.d/ser2net/run

@@ -0,0 +1,9 @@
+#!/usr/bin/with-contenv bashio
+# ==============================================================================
+# Add-on: 3dprinter-remote
+# Runs ser2net
+# ==============================================================================
+
+bashio::log.info "Starting ser2net.."
+
+exec ser2net -d

3dprinter-remote/rootfs/usr/share/tempio/ser2net/ser2net.conf.gtpl

@@ -0,0 +1,2 @@
+9999:raw:0:{{ .printer_path }}:{{ .printer_baudrate }} {{ .ser2net_args }}
+BANNER:banner1:Welcome to ser2net \rTCP port \p device \d\r