diff --git a/README.md b/README.md
index 1064a7e..a983444 100644
--- a/README.md
+++ b/README.md
@@ -165,32 +165,11 @@ You can also add mechanical buttons to pause, resume and change filaments near o
 
 **Advanced Area**
 
-If you want to enable notifications check the following issue:
-https://github.com/vitormhenrique/OctoPrint-Enclosure/issues/36
+If you want to enable notifications check the following [issue](https://github.com/vitormhenrique/OctoPrint-Enclosure/issues/36)
 
-You can enable GCODE commands to control configured **outputs**.
-
-The list of supported gcodes:
-
-* Regular outputs
-<pre><code>ENC O[id] S[value]</code></pre>
-Id is generated on the setting plugin, value can be 0 to turn OFF the output or 1 to turn ON output. Ex: sending ENC O2 S1 would turn ON output 2.
-
-* PWM outputs
-<pre><code>ENC O[id] S[pwm value]</code></pre>
-Id is generated on the setting plugin, value is the duty cycle from 0 to 100. Ex: sending ENC O5 S75 would turn set duty cycle of 75% on output 5.
-
-* Neopixel
-<pre><code>ENC O[id] R[red value] G[green value] B[blue value]</code></pre>
-Id is generated on the setting plugin, value should be between 0 to 255. R, G, and B are the colors for that value. Ex: sending ENC O1 R255 G0 B0 would set neopixel with id 1 color to full red.
-
-* Temperature / Humidity Control
-<pre><code>ENC O[id] W[wait value] S[set value]</code></pre>
-Id is generated on the setting plugin, W specify if the plugin should wait or not for the enclosure to reach the temperature (1 is to wait), S will set the set temperature. Ex: ENC O1 W1 S45 will set temperature control with id 1 to 45 and wait until the temperature is reached to continue printing.
-
-It is possible to send and request GPIO status with web requests, check this issue for more information:
-https://github.com/vitormhenrique/OctoPrint-Enclosure/issues/85
+You can control outputs using a simple [API](https://github.com/vitormhenrique/OctoPrint-Enclosure/wiki/API-Control)
 
+Or use [g-code](https://github.com/vitormhenrique/OctoPrint-Enclosure/wiki/G-CODE-Control) commands
 
 **Tab Order**